earth moving
Everything you wanted to know about Construction!
  • About
  • Contact
  • Privacy
  • About
  • Contact
  • Privacy
  • Home
  • /
  • General

Directional Drilling

Directional drilling is one of the oldest forms of drilling used. The oil and gas industry is generally regarded as one of the most profitable in the world, and in this respect, it is only logical that we would continue to build upon its most basic foundations. A lot of innovation has been done in the direction of hydraulic directional drilling, however, its origins are as old as they come.

Directional drilling is essentially about pushing a machine to obtain a particular hole in a deep or semi-deep well. It works by inserting a piece of mesh, known as a subsea cord, into the well, then using a plunger, which is part of the machine, to create a rough excavation. This is known as subsea drilling. The vertical part of the plunger is known as the cylinder, which is driven through the well by the hydraulic field of a directional drilling machine.

Directional drilling Brisbane are very versatile in the sense that it can drill holes for pipelines as well as deep wells. It can even be used to perform relief drilling, or maintenance to a buried pipeline, such as is done on oil pipelines. The main advantage of directional drilling is that it is much faster than other types of drilling. As far as reliability is concerned, it is much less likely to go wrong, but it still takes longer to complete an operation.

The hydraulic field of a directional drilling machine is located at one end of the subsea cord. It is pushed up the hole by the use of a large amount of hydraulic pressure. The whole operation is done by pulling the cord, which goes out of the hole that was excavated. This leaves the hole open for subsequent operation, while also carrying the cord back up the hole.

Not all drilling rigs are designed for drilling in both directions, and it is up to the operator to decide which type of drilling they want to use. The depth limit of the shaft is also another factor to consider when deciding which direction to use.

Dividing an area in two is one of the main methods used for the purpose of directional drilling. In some cases, they are also used to put points of interest, such as monuments, in a particular place.

Directional drilling is not used nearly as much as it once was, as the technology has advanced to the point where it is now possible to drill all over the world without having to drill into a seam of water at all. However, it is important to remember that directional drilling is much easier to use than hydraulic, and with proper planning and finesse, directional drilling can be used to almost any location. It is still, however, far more efficient than hydraulic drilling.

Posted on January 23, 2020 by Marion Jenkins. This entry was posted in General. Bookmark the permalink.
THE DO’S AND DON’TS FOR WORKING WITH ASBESTOS
Shotcrete Brisbane – A Good Way to Build Basement Walls

    Categories

    • ASBESTOS
    • General
    • Property

    Recent Posts

    • Ground Stabilization Contractors
    • Shotcrete Brisbane – A Good Way to Build Basement Walls
    • Directional Drilling
    • THE DO’S AND DON’TS FOR WORKING WITH ASBESTOS
    • How can no property maintenance puts your property risk

    Places on the Net

    .
    Visit Hipages

Powered by